Original FCC: LabDron runs as DJI Fly with FCC built in. No extra app, no command sent every 2 seconds. See the difference
LabDron

LabDron DJI FCC Android Installation Guide

Related product: LabDron DJI FCC Android

NEW VERSION — UPDATE NOTE: If an older version of this app is installed on your phone, uninstall it first (the signing key was renewed, so it cannot be installed over the old one). Your username and password stay the same.

IMPORTANT: Follow the steps in order. If you get stuck, contact our WhatsApp support line at +90 850 308 46 50.

What you need

  • 64-bit (arm64) Android phone, Android 8 or newer
  • At least 2 GB free space on the phone (the file is about 700 MB)
  • Internet (Wi-Fi or mobile data) for the first sign-in

Package contents

Once your activation is complete, download LabDron-DJI-FCC-Android.apk with the Download button on My Account → My Activations. It is a single file; you can download it directly on the phone.

Step 1 — Uninstall the original DJI Fly

  1. On your phone go to Settings → Apps → DJI Fly → Uninstall. The LabDron build uses the same package name, so it cannot be installed while the original is present.

Step 2 — Install the APK

  1. Tap the downloaded LabDron-DJI-FCC-Android.apk file.
  2. If asked, allow installation from unknown sources and tap Install. The file is large, so installation can take 1-2 minutes.

Step 3 — Sign in

  1. Open the LabDron app while the phone is not connected to the controller.
  2. Enter the username and password you chose at checkout. They are shown on the My Activations page.
  3. Once the sign-in is confirmed, close and reopen the app. The license is bound to this phone; the app then works offline, but to keep the license active, connect the phone to the internet and open the app at least once every 30 days (otherwise FCC turns off and you need to sign in again).

Step 4 — Fly

  1. Attach the phone to the controller, power on the drone and enable FCC and the features you want from the app's control panel.

Troubleshooting

  • "App not installed": the original DJI Fly or an older LabDron build is still installed; repeat step 1.
  • "Device change" warning: the license is bound to another phone; ask support for a device reset.